How to Build a Tool Storage Cabinet?

The first step to get organized is to utilize one storage cabinet or one of many. If you're someone that is handy with tools and like to craft with wood, then try your hand at building a storage cabinet yourself.

They are fairly easy to build and are even fairly inexpensive. A storage cabinet is will not take very long to build either and this article will show you how. Before you start you need to know what you will need.

Covered-storage-cabinet Covered-storage-cabinet
source:hngideas

What you will need!

  • Nails
  • Hammer
  • Stain (or paint)
  • Sander
  • Sandpaper
  • Protective glasses
  • Hinges
  • Knobs
  • Various other hardware
  • Saw
  • Measuring tape
  • Paper
  • Pen
  • Wood
  • Wood glue

    images images
    source: funnelholic

Here are some of the tips which will help you to build a Tool Storage Cabinet

  1. Use a circular saw to crosscut a 4x8-foot sheet of ¾-inch A-C plywood down to 5 feet long.
  2. Rip the ¾-inch plywood to width on a table saw to form the cabinet's top, bottom, sides and center divider.
  3. Adjust the table saw blade and rip fence to cut a rabbet into the rear edge of the two sides of the cabinet.
  4. Install a stacking dado blade in the table saw and cut shallow grooves in the cabinet sides and center divider for metal shelf standards.
  5. Screw a shelf sides of the groove which was cut by the dado blade.
  6. Use a pocket-hole jig to bore pocket-screw holes into the ends of the cabinet's top and bottom.
  7. Fastly apply the top and bottom to the sides with 2-inch pocket screws.Place the center shelf between the top and bottom and hold it place with a bar clamp. Secure the shelf with some of 2-inch screws.
  8. Then Cut the cabinet back from ½-inch plywood.
  9. Lay the cabinet face down. Apply carpenter's glue to the every side of the cabinet, and also on the edge of the top, bottom and center divider.
  10. Set the ½-inch plywood back into a place where the glue was added and tack it with a pneumatic pin nailer and 1-inch pin. Secure the back with 1 ?-inch screws.
  11. Then Use a miter saw to crosscut 1x3 pine to the length of the tenon; make two vertical stiles and two horizontal rails for each cabinet door.
  1. Then, use the table saw to cut grooves on to the edges of the stiles and rails to accept the ¼-inch make slice hole to the hardboard panel.
  2. Adjust the table saw blade and rip fence, and use a miter gauge to cut a tenon into both ends of each rail.
  3. Then Use the table saw to cut two door panels from ¼-inch make slice hole on hardboard.
  4. Spread some of the glue onto the tenons and then clamp two rails to one stile. Tack together each corner joint with a pin nailer and ?-inch pins.
  5. Then Slide the door panel into the grooves cut in the doorframe, then glue and nail on the remaining rail of the cabinet. Don't apply glue to the door panel.
  6. Repeat the same Steps 16 and 17 to assemble the second door.
  7. Attach the doors to the cabinet with continuous piano hinges for maximum strength.
  8. Fasten apply one pull handle to each door.
  9. Then Cut and install four ¾-inch plywood shelves.
  10. Then finally Mount the cabinet to the wall, making sure you screw securely tight into the wall studs.

Here are some of the tips which will help you to work with How to Build a Tool Storage Cabinet. If you guys have any question or queries you can comment below.